Sears 113.2945 - Manual (Page 3)

ASSEMBLING AND ADJUSTING YOUR SAW
UNPACKING AND CHECKING CONTENTS
This Craftsman 10-inch Radial Saw is shipped complete in
one carton. In order to prevent damage during shipment
and facilitate packaging, certain items are removed at the
factory and must be assembled when received by the pur­
chaser. These "loose" items are listed below and should be
accounted for before discarding any packing materials.
Key No.
(Fig. 1) Item Name Qty.
1 Table Support, Left-hand ........................... 1
2 Table, Front ................................................. 1
3 Table, Rear ................................................... 1
4 Table, Spacer ............................................... 1
5 Fence, Rip .................................................... 1
6 Table Support, Right-hand ........................ 1
7 Owner's Manual .......................................... 1
8 Unpacking Instructions ............................. 1
9 Shaft Wrench ............................................... 1
10 Arbor Wrench.............................................. 1
11 Pack Assm., Loose Parts
(containing the following):
Wrench, Hex-L, 1/8" ............................... 1
Wrench, Hex-L, 3/16".............................. 1
Wrench, Hex-L, 1/4"................................ 1
Wrench, Hex-L, 5/16".............................. 1
Washer, Plain, 11/32x7/8x1/16" 4
Lockwasher, 5/16 X .125 X .078" ... 4
Screw, Hex. Hd. 5/16-18 x 3/4" . . . 4
Screw, M. Pan. SI., 1/4-20 x 1" . . . . 6
Washer, Plain, 17/64 x 5/8 x 1/32" 7
Lockwasher, Steel, 1 /4 x .109 x .062" 6
Nut, Hex., 1/4-20 X 7/16 X 3/16" .. 6
Nut, Tee ................................................... 1
Key No.
(Fig. 1) Item Name Qty.
Screw, M. Pan. SI., 1/4-20x1-1/4" 1
Screw, Si. Cup Pt., Set, 1 /4-20 x 1 /2"
Screw, Type A, Pan Hd., SI., 1
No. 10x5/8"..........................................
Screw, Type 23, Pan Hd., SI.,
4
No. 6-32x5/16" .................................... 2
Nut, U-Clip (1/4-20) ................................. 1
Clamp, Table ........................................... 2
Switch Key .............................................. 2
Shoe, Carriage Lock ............................... 1
Knob, Carriage Lock............................... 1
Indicator, Rip .......................................... 1
Nut, Twin ................................................. 1
Bracket, Rear Table Support................. 2
POWER SUPPLY AND MOTOR DATA
MOTOR SPECIFICATIONS
The a-c motor used in this Craftsman Radial Saw is of
the capacitor start, non-reversible type with the following
specifications;
Voltage ...........................................................120
Amperes ....................................................... 12.5
Hertz ................................................................ 60
Phase ........................................................ Single
RPM...............................................................3450
Rotation (viewing saw blade end) Clockwise
CAUTION: This motor is wired for 120 volt
operation. Connect to 15 ampere branch
circuit and use a 15 ampere time-delay fuse.