Training, Preparation, Operation – Sears 580.7515 User Manual
Page 2: Maintenance and storage, Safety rules
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

A
SAFETY RULES
CAUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND PLACE WIRE WHERE IT CANNOT CON
TACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SETTING UP, TRANSPORTING.
ADJUSTING OR MAKING REPAIRS TO YOUR HIGH PRESSURE WASHER.
A
TRAINING:
•
Engine exhaust gases contain DEADLY cartx)n mon-
oxiaa gas. This dangerous gas, if breathed in suffi
cient concentrations, can cause unconsciousness or
even death. Operate this equipment only in the open
air where adequate ventilation is avail^ie.
•
Gasoline is highly FLAMMABLE and ite vapors are
EXPLOSIVE. Do not permit smoWng, open flames,
sparks or heat in the vicinity while handling gasoline.
Avoid spilling gasoline on a hot engine. Allow unit to
cool for 2 minutes before rehreling. Comply with ail
laws regulating storage and handling of gasoline.
•
Locate this pressure washer in areas away from com
bustible materials, combustible himes or dust
•
The high pressure equipment is designed to be used
with Sears authorized parts only. If you use this
equipment with parts that do not comply witii minimum
specifications, tiie user assumes all nsks and Uni
ties.
•
Some chemicals or detergents may be harmftjl if
inhaled or ingested, causing severe nausea, fainting
or poisoning. The harmful elements may cause prop
erty damage or severe injury.
•
Do not. allow CHILDREN to operate the Pressure
Washer at any time.
PREPARATION:
•
Operate engine only at governed speed. Running tiie
engine at excessive speeds increases tiie hazard of
personal injury. Do not tamper with parts which may
increase or decrease the governed speed.
•
Do not wear loose clothing, jewelry or anything that
may be caught in the starter or other rotating parts.
•
Before starting the Pressure Washer in cold weather,
check all parts of the equipment and be sure ice has
not formed ttiere.
•
Units with broken or missing parts, or without protec
tive housing or covers should NEVER bo operated.
•
The muffler and air cleaner must be installed and in
good condition before operating tiie Pressure Washer.
These components act as spark arrestors if the engine
backfires.
•
Check the fuel sptem for leaks or signs of deteriora
tion such as chafed or spongy hose, loose or missing
clamps or damaged tank or cap. Correct all defects
before operating the Pressure Washer.
OPERATION:
•
Do not spray flammable liquids.
•
Never aim the gun at people, animals or plants.
•
Never allow any part of the body to come in contact
with the fluid stream. DO NOT come in contact with a
fluid stream created by a leak in the high pressure
hose.
•
High pressure stream of fluid that this equipment can
prrauce can pierce skin and its underlying tissues,
leading to serious injury and possible amputation.
•
High pressure spray can cause paint chips or other
partides to become airborne and fly at high speeds.
Always wear eye protection when you use tiiis equip
ment or when you are in the vicintty where the equip
ment is in use.
Operate the pressure at no more than the PSI fluid
pressure rated for your pressure washer.
Never move the machine by pulling on the high pres
sure hose. Use tfie handle provided on tiie top of the
unit
Always be certain the spray gun, nozzles and acces
sories are correctly attached.
Never use a spray gun which does not have a trigger
lock or trigger guard in place and in working order.
Use a respirator or mask whenever there is a chance
that vapors may be inhaled. Read all instructions with
the mask so you are certain the mask will provide the
necessary protection against inhailng harmful vapors.
High pressure spray may damage ftegile items includ
ing glass. Do not point spray gun at ^ass when in the
Jet spray mode.
Keep the hose connected to machine or the spray gun
while the system is pressurized. Disconnecting the
hose while the unit is pressurized is dangerous.
Hold the spray gun fiimiy in your hand before you start
the unit Failure to do so could result In an injury from
a whipping spray gun. Do not leave the spray gun
unattended while the machine is running.
The cleaning area should have adequate slopes and
drainage to reduce the possibility of a fall due to
slippery surfaces.
Keep water spray away from electric wiring or fata!
electric shock may result
Do not adjust unloader valve to a pressure in excess
of machine rating.
Do not secure trigger gun in the pull-back (open)
position.
Do not by-pass any safety device on this machine.
Do not leave tiigger closed for more than 5 minutes
with engine running. This could damage the pump.
The muffler and engine heat up during operation and
remain hot immediately after shutting it down. Avoid
contact with a hot muffler or engine or you could be
severely burned.
MAINTENANCE AND STORAGE:
Operate and store this unit on a stable surface.
High pressure hose can develop leaks from wear,
kinking, abuse, etc. Water gjraying from a leak is
capable of injecting material into skin. Inspect hose
each time before using ft. Check all hoses for cuts,
leaks, abrasions or bulging of cover, or damage or
movement of couplings. If any of these conditions
exist, replace hose immediately. Never repair high
pressure hose. Replace it with another hose that
meets minimum pressure rating of your pressure
washer.
A
LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT
SAFETY PRECAUTIONS. IT MEANS "ATTENTION!» BE
COME ALERT»! YOUR SAFETY IS INVOLVED.“