Carrier 51CV/GY - Manual (Page 10)

WINDOW INSTALLATION
STEPS
TOOLS YOU WILL NEED FOR
INSTALLATION
Screwdrivers—Both Phillips and reguiar head types
Power drill (1 /8" dia. drill bit)
Pencil
Measuring Tape
Scissors or a razot^edged knife
NOTE: To install your room air conditioner in a double-
hung window, contact your independent Carrier Dealer
for an Accessory Window Installation Kit.
I Remove air conditioner from box by breaking
away sides of box (cutting box could result in
damage to unit).*1
I
Remove two shipping screws at bottom of
casing’s rear panel.
Remove front grille with filter.
I
Remove securing screws and lift grille frame
off chassis and away from casing.
I
Loosen chassis security screw, located above
control panel, and slide to unlocked position.*2
I While one person holds back of casing,
second person slides chassis out from casing.
NOTE: Coil fins on chassis are sharp and chassis
is heavy.
I
Place casing and chassis aside while prepar­
ing window for installation.
I
Place unit on stable surface for remainder
of steps.
I
Remove bottom track from Accessory Window
Installation Kit.
NOTES
PRIOR to installation, plug in unit and verify operation. Refer
to operating instructions. Some clicking and gurgling sounds
are normal during unit operation. If you received a damaged
ornon-functioning unit, contact your dealer.
If storm window is present, see Step 10 before starting.
*1 Two people recommended for installation.
*2 Unit has slide-out chassis design witii easy access for serv­
ice or maintenance needs. A special locking screw secures
the slide-out chassis to prevent unit from being forced out
through the casing to the house, thus preventing an intruder
from gaining entry from the outside.