Compaq MTEK6000 - Manual (Page 72)

MTEK6000 SERIES USER'S MANUAL
E-2 January 2002
CANADIAN “INDUSTRY CANADA”
NOTICE
The Industry Canada label identifies certified
equipment. This certification means that the
equipment meets telecommunications
network Protective, operational and safety
requirements as prescribed in the appropriate
Terminal Equipment Technical Requirements
document(s). The Department does not
guarantee the equipment will operate to the
user’s satisfaction.
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company. The equipment must also be
installed using an acceptable method of
connection. The customer should be aware
that compliance with the above conditions
may not prevent degradation of service in
some situations.
Repairs to certified equipment should be
coordinated by a representative designated by
the supplier. Any repairs or alterations made
by the user to this equipment, or equipment
malfunctions, may give the
telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection
that the electrical ground connections of the
power utility, telephone lines and internal
metallic water pipe system, if present, are
connected together. This precaution may be
particularly important in rural areas.
CAUTION
Users should not attempt to make such
connections themselves, but should contact
the appropriate electric inspection authority,
NOTICE
The Ringer Equivalence Number (REN)
assigned to each terminal device provides an
indication of the maximum number of
terminals allowed to be connected to a
telephone interface. The termination on an
interface may consist of any combination of
devices subject only to the requirement that
the sum of the Ringer Equivalence Numbers
of all the devices does not exceed 5.
Ringer Equivalence Number [0.8B]
WARRANTY & REPAIR SERVICE
Repair & Return Department
Metretek, Inc.
300 North Drive
Melbourne, Florida 32934
(800) 327-8559
or an electrician, as appropriate .
To be supplied when final Class 1, Div 1 & Div 2 approvals for this unit are received