Winco Mfg. S400 - Transfer Recliner - Manual (Page 3)

Page 3 of 8
006195 Revision GG Date 06-28-13 JWC
· FIG. 5: Transfer of Patient
(1) Lower the adjustable arm that is adjacent to
the transfer surface.
(SEE FIG 3 on preivious page)
● Position the Transfer Recliner as close as
possible to the surface patient is to be
transferred to/from.
(2) Engage all 4 - Total Lock Casters. This
locks both the swivel mechanism and wheel.
(3) Make sure the fold-out Footrest is folded up.
(4) Keep opposite arm raised to prevent patient
from sliding off Transfer Recliner during
transfer.
(5) If a 180 degree (flat) transfer is desired,
squeeze the Release Lever on top of Back
Frame and lower Back of recliner to flat
transfer position.
When the Release Lever is released, the
Transfer Recliner back will stay in desired
position.
● Transfer patient to/from the Transfer Recliner according to your
facilities’ recommended safety guidelines.
● Check for proper patient positioning, then raise Transfer Recliner Arm securely in place. (FIG. 3)
● Adjust the Back, Footrest and Seat Belt for optimal patient comfort, safety and support as needed.
Stay clear of the recline mechanism. Periodically recheck tightness of all screws and bolts.
BE SURE BOTH ARMRESTS HAVE BEEN FULLY TIGHTENED
PRIOR TO PATIENT ENTRY/EXIT.
FIG 5