Winco Mfg. Room Chair 6704 - Manual (Page 8)

OPERATING INSTRUCTIONS cont'd.
SIDE PANEL - REMOVAL / REPLACEMENT
(For Care Cliner Models ONLY)
1. For ease of cleaning and chair maintenance;
Unscrew two (2) thumbscrews at the front of chair
and one (1) thumbscrew at the rear of chair, on
inside of each panel. (FIG. 1)
2. Replace panel and re-install three (3) thumb-
screws & clear washers (FIG.2) when cleaning or
maintenance of chair is complete.
DROP-ARM VINYL PANEL
(For Drop-Arm Care Cliner Models ONLY)
1. The vinyl panel is secured to the bottom of the Drop-
Arm with a hook & loop fastener material. Peel hook
& loop apart to allow ease of cleaning and access
behind the Drop-Arm of the chair.
(FIG. 3 & 4)
2. Re-attach by aligning and firmly pressing the hook &
loop material back together.
7
SWING-ARM OPERATION
(For Models: 6740-6750-6940-6950 only)
1. To open, depress the red latch handle to unlock the
swing-arm. (FIG. 4)
2. To close, push swing-arm toward latch until latch
engages. (FIG. 4)
FIG. 2
FIG. 3
FIG. 4
FIG. 1
6740 & 6750 Models
DO NOT have an attendee in the trendelenburg
position (pg.5) while both swing-arms are open.
May cause tipping of chair.