Winco Mfg. Room Chair 6704 - Manual (Page 11)

10
GENERAL MAINTENANCE (cont’d)
REPLACING RECLINING MECHANISM
1. Remove Care Cliner back and put aside.
(see Back Assembly Instructions page 4)
2. Position recliner so that the recline mechanism,
located on the chair frame, is accessible.
Remove the 4 bolts that attach the recline
mechanism to the chair frame.
(FIG 1)
3. Remove the recline mechanism, and the
attached Seat Frame assembly from the chair
Main Frame. Turn the Seat Frame & mechanism
assembly upside down on a table or other stable
surface. (FIG 2)
4. Remove all screws that attach Footrest, Mid-
Ottoman, Legrest, and Seat from the damaged
recline mechanism.
(FIG 3)
5. Re-attach the Seat, Legrest, Mid-Ottoman, and
Footrest to the new mechanism. Re-assemble
the Seat/Recline Mechanism Assembly to the
chair frame using (4) new locknuts and the
bolts that were previously removed. (FIG 1)
REGULARLY lubricate pivot points on the
Recline Mechanism with a silicone based
lubricant.
Once per week, position the Chair Back into
full recline position, squeeze release handle
and go to full Trendelenburg position. This will
keep the gas cylinder lubricated.
Periodically recheck tightness of all screws,
bolts and nuts.
IMPORTANT !
FIG. 1
FIG. 2
FIG. 3
GENERAL CARE & CLEANING
Remove hair & body oils; Your recliner should be
cleaned with mild soap & water solution and a damp
cloth on a regular basis (especially where skin &
hair make contact with upholstery). Avoid harsh
detergents or chemicals that could damage the
upholstery or finish of your recliner. If the recliner is
disenfected, the chair MUST be wiped off with ONLY
clean water on a damp cloth.
Note: Disinfectants alone, will not provide adequate
"grease or oil cutting" properties to remove hair &
skin oils. Over time, the appearance and feel of your
upholstery may diminish if not cleaned properly.
Please refer to the PERMABLOK
instruction tag that is attached to your Care Cliner
for complete care and cleaning instructions.
Retain information on tag for future use.
FOR FURTHER CLEANING INFORMATION VISIT:
http://www.wincomfg.com/permablok-info-and-cleaning-instructions