Winco Mfg. 2588 - Power Designer Blood Drawing Chair - Padded vinyl - Manual (Page 8)

8
Arm Installation - All models
FIG. 6 FIG. 7
Glide Foot Installation
1. Place chair on side and install (4) Glide Feet in threaded holes on the bottom of the Chair Frame (FIG. 6 & 7).
Lift & position the chair to the upright position, with Glide Feet on a level fl oor.
2. If the Chair Frame does not sit level on the fl oor, loosen one or two of the Glide Feet individually and adjust until
the Chair Frame is level .
FIG. 6a FIG. 7a
FIG 6 & 7
2570-2571-2572
2573-2574-2575
FIG 6a & 7a
2578
FIG. 1
1. If the Arm Assembly has not yet been installed, insert it into the Receiving
Tube on Seat Frame Assembly. (This applies to any style arm assembly)
•ALWAYS make sure that the slot in the Arm Assembly faces the Knob
installed on the receiving tube. (FIG. 1)
2. Then adjust the arm to the desired height and tighten the knob. Screw the
Knob into the Slot. This will “capture” the arm and keep it from being able to be
pulled out of the frame accidentally.
DO NOT OVERTIGHTEN - The Knob will NOT need to be extremely tight to
effectively hold arms in position.
FIG. 6b FIG. 7b
FIG 6b & 7b
2588
Glide Foot Installation - All models