Viconics VT7600 Installation Guide (Current Release 5000 Series PIR Ready) - Manual (Page 2)

2 | PIR Ready VT7600 Series-Installation Guide
I
NSTALLATION
Remove the security screw on the bottom of
Terminal Equipment Controller cover.
ƒ Open unit by pulling on the bottom
side of Terminal Equipment
Controller (fig. 1).
ƒ Remove wiring terminals from sticker.
ƒ Please read the FCC ID and IC label
installed in the cover upon removal of
cover for the wireless products.
Location
1. Should not be installed on an outside
wall.
2. Must be installed away from any
direct heat source.
3. Should not be installed near an
air discharge grill.
4. Should not be affected by direct
sun radiation.
5. Nothing should restrict vertical
air circulation to the Terminal
Equipment Controller.
Installation
1. Swing open the Terminal
Equipment Controller PCB to
the left by pressing the PCB
locking tabs (fig. 2).
2. Pull out cables 6” out from the
wall.
3. Wall surface must be flat and
clean.
4. Insert cable in the central hole
of the base.
5. Align the base and mark the
location of the two mounting
holes on the wall. Install proper
side of base up.
6. Install anchors in the wall.
7. Insert screws in mounting holes
on each side of the base (fig. 2).
8. Gently swing back the circuit
board on the base and push on
it until the tabs lock it.
9. Strip each wire 1/4 inch from
end.
10. Insert each wire according to
wiring diagram.