VACUUBRAND MV 10C VARIO - Manual (Page 19)

page 19 of 51
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. manual-no.: 999073 / 15/12/2009
setting pressure unit (mbar / Torr / hPa)
configuration of the coolant valve if applicable
setting basic setup
ready to
start
basic setup ”vacuum control” (factory set)
controller controls
-
pump according to preset pressure value or in automatic mode
- coolant valve (optional)
- venting valve (optional)
basic setup ”VACUU•LAN”
controller controls
-
pump according to preset pressure and time values
- coolant valve (optional)
- venting valve (optional)
General view basic setups
basic setup ”continuous pumping”
controller controls
-
pump according to preset pumping speed
- coolant valve (optional)
- venting valve (optional)
configuration of the venting valve if applicable
CVC 2000 II