USL ECI-60 - Manual (Page 6)

- 10 - - 11 -
In the “Communications” tab you may choose to “Connect” to an ECI-60 or
confi gure your “Communications Settings” When changing communications set-
tings, the ECI-60 must not be connected to the setup software.
Selecting “Communications Settings” presents you with the above window in
which you may confi gure your communications settings appropriately with “Com1”
through “Com9” and TCP/IP if your access to the ECI-60 is through a network.
After you have achieved connection, the Format buttons will change color and, if
you are connected to a piece of equipment, you may see movement in the “Out-
put Level” window. At this point, you are operating with the “Default” processor
so it is now time to select a processor. To do this, select the “Change Settings”
button.
Selecting the “Change Settings” button will bring up the leftmost of the two dialogs.
To select your processor for operation, you will need to access the drop down
window as shown in the right graphic above. You may then choose a “power on”
mode and “Power On Format”. If Film/Bypass is selected, the ECI will not trigger
the connected processor at unit power up.
An automation pulse can be sent during a Digital to Film mode transition. If None/
Bypass is selected, no automation pulse will be generated when transitioning from
Digital to Film mode.