TruTrak EFIS AP (8300-057C) - Manual (Page 15)

EFIS SOFTWARE UPDATES
Compact Flash Card Slot
The EFIS software is updated by inserting a Compact Flash card (CE) in
the back top slot. With the back of the card up. Software is available from
TruTrak to install on a flash card. Then apply power to the EFIS and
monitor the screen. Follow the instructions on the screen. When power is
reapplied to the EFIS, the new software will be installed.
If more than one unit is updated the software load will take longer.
Confirm the update by watching the display lower left side on startup for
the version number change.
PITOT STATIC
ENGINE INFORMATION
With the optional Engine Data
Module coupled to the EFIS the
display will be able to show engine
information at the top. The Trim
indicators will only be displayed
when trim adjust is performed or
below VSO.
TruTrak Flight Systems 13 EFIS Autopilot Installation Manual
The parameter reading will display
yellow when entering the yellow a
There will be a warning box at the bottom of the display when the parameter first enters the red arc. see
OIL PRESSURE. ACK will remove the warning box and VIEW will change the page to the detailed view
etail
rc.
.
ed information is located
-up will
l
ays be
T DIRECTOR
e up when the FD button is pressed will
S to
b to
e
D
under the PAGE button.
The first page after power
show the timer page so that the fue
and or trip information can be
updated before engine start.
The HSI information can alw
returned to by clicking the MAIN
button.
LIGH F
he magenta wings that com T
show the aircraft positioning to follow to maintain TRK, VSI, NAV,
etc. commands. All the pilot has to do is keep the triangle in the
wings as they move to follow the commands the pilot told the EFI
perform. Example: A change in
TRK will command the wings to
bank in the direction to acquire the new TRK. A command to clim
a new altitude will cause the wings to move up on the horizontal plan
to acquire the new altitude.
April 2009 8300-057 Rev D