TriangleTube 110 Solo User Manual

Page 18

Unit Preparations

SECTION III - Unit Preparations

Handling Instructions

The PRESTIGE Solo is generally easier to
handle and maneuver once removed from the
shipping carton and pallet.

To remove the shipping carton and pallet:

Use care not to lift the unit from, or place
the unit on the front plastic control
panel, damage can occur. Use care not to
drop, bump or rotate the boiler upside
down, as damage to the boiler will result.

1. Remove any shipping straps and open the

side of the shipping carton.

2. Slide the unit with the foam inserts out of

the carton.

3. Discard all packing materials.

Wall Mounting Installation

The PRESTIGE Solo should be wall mounted
using the bracket kit provided with the boiler.
The PRESTIGE is not designed for floor instal-
lation. If floor installation is required an
optional floor stand is available through
Triangle Tube.

The wall used for mounting the PRES-
TIGE Solo must be vertically plumbed
and capable of supporting a minimum
130 pounds [59 Kg]. Failure to comply
with these requirements could result in
personal injury, death or substantial
property damage.

Wall Mounting Guidelines

1. The wall-mounting bracket is designed for

stud spacing of 12 inch or 16 inch on cen-
ters. For unconventional stud spacing, a
solid / secure mounting surface must be
provided for installation of the bracket.

2. For applications using wood studs, install

the bracket using the lag screws provided
with the boiler. Ensure both lag screws are
installed securely in the studs.

3. For applications using metal studs, install

the bracket to the studs using 3/16” toggle
bolts and washers.

4. DO NOT mount or attempt to mount the

wall bracket to hollow sheet rock or lathe
walls using anchors. Only install boiler to
studs or equivalent wood structure.

5. For applications using solid walls (rock,

concrete, brick, cinder block, etc.), install
the wall bracket using anchors (double
expansion shields) and bolts with washers
provided with the boiler.

6. The boiler is too heavy and bulky for a sin-

gle person to lift and attempt to mount; a
minimum of 2 people is required for
mounting the boiler.

Use extreme care not to drop the boiler
or cause bodily injury while lifting or
mounting the boiler onto the bracket.
Once mounted verify that the boiler is
securely attached to the bracket and
wall. Failure to comply with the above
guidelines could result in property dam-
age, personal injury or death.

Wall Bracket Installation - Stud Walls

1. Locate the studs in the general area of the

boiler placement.

2. Place the wall-mounting bracket on the

wall centering the mounting slots with the
stud centers and ensuring the upper edge of
the bracket is away from the wall.

3. Level the bracket, while maintaining it’s

centering with the studs and use a pencil to
mark the location of the mounting slots.

WARNING

CAUTION