Toa C-IF500 - Manual (Page 8)

133-12-742-1G
6. SPECIFICATIONS
Notes
• The unit cannot be used in the system with the transmission/reception switching interval of 2 bytes or less or
where transmission signals could be simultaneously sent out from multiple slave terminals.
• The design and specifications are subject to change without notice for improvement.
* 1 Communications cannot be made between slave terminals.
* 2 Applies to the system where the unit and Combination camera are connected in a matched pair.
Represents the total of connected cable distances if multiple Combination cameras or Interface units are
connected in the system (when the CPEV-S cable thicker than 0.65 mm in diameter is used).
• Optional Equipment
MB-15B-BK Rack mounting bracket (for rack mounting one C-IF500 unit)
MB-15B-J
Rack mounting bracket (for rack mounting two C-IF500 units)
Power Source 12 V DC
Current Consumption 100 mA
External Control Master: RS-485, screwless connector,
terminating resistance (100 Ω) switch ON/OFF
Slave* 1 : 4 channel, RS-485, screwless connector, RS-232C,
D-sub connector (9-pin, male)
Display Power LED indicator, communication LED indicators (TX, RX)
Maximum Cable Distance RS-485: 1.2 km* 2
RS-232C: 10 m
Communication Speed 4800 bps, 9600 bps, 19200 bps, 38400 bps
Operating Temperature –10 to +50 ° C
Operating Humidity Under 90% (no due condensation produced)
Finish Panel: Aluminum, black (30% glossy), paint
Case: Pre-coated steel plate, black (30% glossy)
Dimensions 210 (w) x 46 (h) x 284.1 (d) mm
Weight 1.4 kg