Toa C-BC704W - Manual (Page 5)

5
Remove
Insert
Rear plate
Sealing points
4. INSTALLATION
4.1. In-wall Wiring
1. Run the composite cable supplied with the C-CC704 through the cable bushing supplied with the unit.
Remove the connectors on the end of the composite cable before running the cable through the cable
bushing.
2. Remove the rear plate from the Wall Mounting Bracket, then run the composite cable with a cable bushing
mounted from the rear plate side.
3. Secure the cable bushing to the rear plate, then replace the removed rear plate to the Wall Mounting
Bracket.
Waterproof 2 points shown in the figure below with silicone sealant material.