Toa M-9000M2 v.2.00 - Manual (Page 75)

75
(Only when the delay function is set to ON)
(B10) Delay time setting
D E L A Y - O N T I M E 0. 0
(B11) Paging output volume setting
P A G I N G - O U T V R : 0
When the selected input channel is set for paging use, sets the output gain.
This set value is saved separately from that for scene memory, so that the paging output level is constant
even when any scene is recalled.
Set the delay time.
Delay time can be adjusted to up to 40 ms in total for the amplifier's Output channels 1 and 2, and for the
paired output channel when the T-001T is used.
For example, when the delay time for Output channel 1 is set to "30," set that for Output channel 2 to "10" or
less. If the delay time for Output channel 2 is set to over "10," that for Output channel 1 is automatically
adjusted so that the total delay time for both channels becomes 40.
0 – 40 ms (default: 0), 1 ms steps
Note
Maximum 40 ms total of time for Output channels 1 and 2.
When the T-001T is used, maximum 40 ms total of time for each pair of Output channels
3 and 4, 5 and 6, and 7 and 8. Setting Range
– ∞, –70 to 0 dB (default: –20 dB), 0.5 dB steps Setting Range