Tie Down LP750 User Manual
Page 11

Page 11
The bleeding operation for that brake is complete when bubbling
stops. Be sure to tighten bleeder screw securely. Each wheel cylinder
must be bleed until all air is out of the lines. Replenish the brake fluid
during the bleeding process so the level does not fall below half full
level in the master cylinder reservoir.
When bleeding and testing is completed, make sure master cylinder
is filled to 3/8” below the top of the reservoir and filler cap is
securely in place.
To release the emergency brake, simply press the E-Stop release
upward (located on bottom front, right side of actuator) you should
here a “click” noise, this will indicate the bracket is released.
After bleeding, make sure the emergency stop is disengaged by
pressing the e-stop release.
Under normal use the e-stop is very loose and easy to push.
Before towing always double check the e-stop by pushing it upwards.
- 660E (16 pages)
- 750E (16 pages)
- 850E (16 pages)
- Drum Brakes (12 pages)
- Torsion Axle (4 pages)
- Eliminator Vented Disc Brakes (12 pages)
- G5 (12 pages)
- Super Lube Hubs (4 pages)
- Vortex Hubs for Spindles (4 pages)
- 66 Actuator (8 pages)
- 70 Actuator (1 page)
- 66 Actuator For Serial #16020 and above (8 pages)
- 66 Weld-On Actuators (2 pages)
- 70 Brake Actuator (8 pages)
- 70E (8 pages)
- 70LP (8 pages)
- 75LP (8 pages)
- LP850 (16 pages)
- 85 Actuator (8 pages)
- 80 Actuator (8 pages)
- 80LP (8 pages)
- 125 Alien Actuator (8 pages)
- 125 Actuator (8 pages)
- 145 Raptor Actuator (8 pages)
- 165 Raptor Actuator (8 pages)
- LP16.5 (8 pages)
- 20 Raptor Actuator (8 pages)
- Back Flow Style Brake Solenoid (1 page)
- Brake Line Kit for "Add On Axles" (2 pages)
- Brake Line Kit for Single Axles (2 pages)
- Brake Line Kit for Tandem Axles (2 pages)
- Brake Solenoid Kit for use with Tie Down's Brake Actuator (1 page)
- Drum Brake Kit for Electric Brakes (4 pages)
- Drum Brake Kit (4 pages)
- Replacement Brake Shoes (4 pages)
- Trailer Brake Flush Kit (1 page)
- TSB - Drum Brakes (2 pages)
- Vortex Hub (2 pages)
- Wheel Hub Kit (1 page)
- Dust Cap (1 page)
- Replacing End Units on Eliminator Torsion axles (1 page)
- Turbo Lube Replacement O-Ring (1 page)
- Turbo Lube (8 pages)
- Spindles Procedure for Removing and Replacing Spindle Wear Sleeves (2 pages)