TeeJet FieldPilot Install Case STX, NH TJ, NH T90X0 - Manual (Page 19)

www.teejet.com
17
FieldPilot ®
8. install the ValVe cOntrOl caBle
The Valve Control Cable will route the same as the steer hoses did in step 4. Connect the cable (F) to the
FieldPilot valve and then route it from the rear of the machine through the middle of the machine forward to
where the harness from the SCM exits the cab.
NOTE: Be sure that the cable is routed in the channels so that it can not come in contact with the drive shaft!
Also route it so that it will not get pinched at the pivot point.
Figure 1-11: Install the Valve Control Cable
F
F
F