Fieldpilot, Channels l disconnect disconnect, Install the steer hoses and adapters – TeeJet FieldPilot Install Case STX, NH TJ, NH T90X0 User Manual

Page 15

www.teejet.com

FieldPilot

4. install the steer hOses and adaPters

The steer hoses will connect from the A & B ports of the FieldPilot valve to the steering cylinders at the pivot

of the machine. The 90º end of hoses

(L)

will connect to the A & B ports of the field Pilot Valve. Route

hoses

(L)

from the rear of the machine through the middle of the machine forward to cylinders. Disconnect

the original steer hoses at the cylinders and install run tee

(Q)

on both cylinders. Connect the original steer

hoses to the run of the tee and connect hoses

(L)

to the branch of the tees.

NOTE: Be sure that the hoses route in the channels so that they can not come in contact with the drive shaft!

Also route the hoses so that they will not get pinched at the pivot point.

Figure 1-7: Install the Steer Hoses and Adapters

Channels

disconnect