TeeJet FieldPilot Install Case SPX 3150-3185 - Manual (Page 17)

16
www.teejet.com
FieldPilot ®
9. install ValVe control caBle
Connect cable (E) to the connectors on the FieldPilot Valve. Route the cable to the right rear of the cab where
it will enter the cab through a plate on the floor. Secure the cable to ensure it will not become tangled in moving
parts.
Figure 1-13: Installing the Valve Control Cable
Valve Cable
10. recoMMended electronics installation
The Steering Control Module (SCM) should be mounted securely to the floor of the cab as far forward in the
cab as possible. The control console can be mounted to the operator’s preference. The GPS antenna should be
mounted as far forward as possible on top of the cab on a metal surface of at least 4” square.
Figure 1-14: Recommended Electronics Installation
Gps Console