TeeJet LH 965 - Manual (Page 8)

LH 965 O PERATORS MANUAL
8 LH A GRO
MAIN MENU
You reach the main menu by pressing the RETURN key until the following reading
is shown:
In this menu you can choose:
OPERATION
normal use of the computer.
ENCODE new encodings or change of the
encoded values.
DATA/DELETE to read or delete/clear data.
TEST
to test the system/sensors.
Select the required function by pressing the function
key to the right of the required function.
OPERATION
When this function has been selected, an optional
information is displayed at the top. However, the first
time the function is selected, speed will always be
shown. The function to show is selected with the 4
function keys.
Next two bars show the loss for straw walkers ( )
and sieves ( ). This reading is the most
important and it therefore uses a relatively large
amount of space. The “ZOOM” key can further
enlarge the bars.
Between the two bars, Ha area override status, full
grain tank, too much loss and reduced cutter bar
width (section) are shown.
Below the grain loss reading the present function of
the 4 function keys is shown.
The options of the function keys are as follows: