TeeJet LH 965 - Manual (Page 13)

LH 965 O PERATORS MANUAL
LH A GRO 13
HA REST
Here the size of the field is to be encoded before start. From this encodement the
endtime will also be calculated.
DATE-TIME
Here the following is set/encoded:
HOURS-MINUTES-SECONDS-YEAR-MONTH-DAY.
THRESHER WARNING
Here you choose if the thresher warning is ON or
OFF. If you want to control the revolutions, the
accepted minimum RPM for the shaft must be
encoded. The present RPM appears on the display
as a help in connection with the encode.
The warning is given with an acoustic alarm and a
warning picture on the display showing which shaft is
causing the warning and the RPMs of the shaft.
The warning picture stays on until the revolutions are
over the warning limit. If the warning is not so serious
that it requires a stop, the warning can be stopped by
pressing the RETURN key, but please note: the
shaft is no longer controlled if the warning has
been stopped with the RETURN key and there will
be no further warnings before the revolutions
have been over the warning limit again or the
computer has been switched off.
STRAW WALKER WARNING
The encodement of warning for straw walker works like THRESHER WARNING.
See above.
CHOPPER WARNING
Encodement of warning for straw chopper works like THRESHER WARNING. See
above.
FANS WARNING
Encodement of warning for van works like THRESHER WARNING. See above.