TeeJet 834 Sprayer Control - Manual (Page 4)

MI 834 Programming and Operating Manual 9/99 Page 4 of 15
Start
To begin the programming process:
☛
Be sure the Master boom switch is “OFF.”
☛
Turn console “ON” by pressing the key. When the control console is turned on, the
software version will be displayed for approximately 5 seconds. At the same time all
LED’s will be ON.
The software version and serial number of the console will be needed when calling for
service support. The serial number is located on a sticker on the back of the console.
Example: the software version is U2.12.
☛
After a short time the console will change to the target application rate display.
Tip
select GPA MPH PSI
On
tip spacing
(inch)
speed cal
(pulses/300ft.)
PROGRAM MODE push 3 sec.
density
U2.12
Tip
select GPA MPH PSI
On
tip spacing
(inch)
speed cal
(pulses/300ft.)
PROGRAM MODE push 3 sec.
density
T20.0