TeeJet BOOMPILOT JOB COMPUTER - Manual (Page 28)

24
www.teejet.com
ISOBUS Job Computer : BoomPilot
®
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
AUTOMATIC OR MANUAL SECTION CONTROL
Automatic mode will turn on ABSC (automatic boom section control).
• Automatically control when boom sections are turned on/off as an applied area is entered/exited.
Manual mode will turn off ABSC. Section control will be controlled by the associated IC18.
Figure 4-6: Auto/Manual Key
1 . 7 7 B . a r e a
5 . 2 0 . 0
0 : 0 0 h h : m m
a c
2
m p h
N o G P S
1. On the Operation Screen , establish Automatic
Operation Mode or Manual Operation Mode by
pressing the AUTO/MANUAL key so that the green
dot is on AUTO (automatic) or the hand (manual)
accordingly.
ALL SECTIONS ON
All Sections On will turn all sections on whether you are in an applied area or not.
Figure 4-7: All On Key
1 . 7 7 B . a r e a
5 . 2 0 . 0
0 : 0 0 h h : m m
a c
2
m p h
N o G P S
1. On the Operation Screen , turn all sections on by
pressing the ALL ON key .
NOTE: Pressing and holding the ALL ON key will
force all sections to remain on. When you release
the ALL ON key , the sections will go back to
the previous mode (auto/manual).