TeeJet BOOMPILOT JOB COMPUTER - Manual (Page 27)

23
98-05210 R0 US
ISOBUS Job Computer : BoomPilot
®
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
APPLICATION BOUNDARY
Application boundaries establish areas where application is and is not applied while using ABSC or BoomPilot.
To establish an application boundary:
Figure 4-4: Boundary in Progress
Figure 4-5: Bounded Area Coverage Status
1 . 7 7 B . a r e a
5 . 2 0 . 0
0 : 0 0 h h : m m
a c
2
m p h
N o G P S
1. Drive to a desired location at the perimeter of the
field/application area.
2. Press START BOUNDARY key .
3. Travel the perimeter of the field/area.
4. Finish boundary:
►Travel to within one swath width of the starting
point. The boundary will close automatically (the
operations screen will begin showing the Bounded
Area Coverage Status in the Bounded Area Status
section).
►Press BOUNDARY FINISH key . A straight line
will complete the boundary between your current
location and the starting point
NOTE: The boundary will not be available if the minimum
distance is not travelled (five-times the swath
width).
To apply without a boundary:
1. Drive to a desired location at the perimeter of the
field/application area.
2. Press NO BOUNDARY key .
3. Begin application.
Bounded Area Coverage Status
Bounded Area Coverage Status displays the amount of
the bounded area that has had application applied to it.