TC-Helicon VoiceTone Harmony-M Manual - Manual (Page 25)

25
My keyboard doesn’t change the harmonies.
What’s wrong?
Confirm Harmony-M is receiving MIDI:
1. Check the dot in the Preset display is flashing when
you play your keyboard. If not set the MIDI channel
according to the directions listed in this manual.
2. Check/replace the MIDI cable
3. Ensure that you are playing keyboard chords made up
of at least a root note and a major or minor third.
The Voice 1 and Voice 2 buttons no longer
work.
Turn off the Manual button.
My FX knob is turned up but the sound is still
dry.
You’re likely set to the Off FX style. Press the FX button
to activate and cycle through the FX styles.
I don’t hear my voice - only harmony and FX.
Lower the Harmony control knob value.
I hear only my dry voice on the Right Out jack.
Hold the Voice 1 and Voice 2 buttons to exit Mono
mode.
How do I talk to the audience with no FX on?
Hold the On footswitch to enter Bypass mode. Press
again without holding to exit.
Can I turn the harmonies off in a preset?
Yes, press either or both of the Voice 1 or Voice 2
buttons so that the LEDs above them are not lit.
I’d like my sound tech to mix the levels. Is that
possible?
Yes. See External Mixing with Mono and Dry Outputs in
the For Advanced Users chapter.
FAQ and Troubleshooting