Front panel – TC-Helicon VoiceTone Harmony-M Manual User Manual

Page 13

14. Preset A and B Select Footswitch

If you only need to access your two favorite sounds in
performance, tapping the A/B footswitch will toggle
between them quickly. If you would like to access more
presets with this footswitch, hold it to enter Preset
select mode. Now, pressing the A/B button cycles
forward through the five “A” preset settings or “B”
preset settings, depending on whether an A or B was
loaded when you held the footswitch.

15. On Footswitch

Tapping this footswitch engages or disengages the
doubling and harmony effects in the current preset. The
reverb and delay FX will remain active on your voice
whether the On LED is lit or not. Holding this footswitch
for one second enters Bypass mode which disengages all
processing except for Tone. This allows you to talk to
your audience without any processing other than the
Tone effect.To exit Bypass mode, hold this footswitch.

Front Panel

A) Change the associated voice’s harmony interval
B) Enable the harmony voice when its LED is off
C) Turn the voice off

Setting the same interval for both voices adds thickness
to the harmony voices.

13. LED Indicator Bar

This translucent bar indicates the A or B selection of
each preset and status of the On footswitch.