TC-Helicon VoiceTone Harmony-M Manual - Manual (Page 21)

21
buttons.To disable CC reception completely, use
the Voice buttons to set a value of 0 in the Preset
display.
o Program Change Receive On/Off (Selected by the
Tone button) - The Tone button configures
whether or not Harmony-M will respond to
program change messages from your keyboard or
sequencer. When the Tone button is lit, program
changes are accepted and this is the default.
o Keyboard Split Point and Zone (Selected by the
FX button) - After pressing the FX button, play a
note on your keyboard to define the split point
and then play a note above or below to determine
whether the active zone is above or below this
note. No display is shown for this so you can test
by playing your keyboard to confirm it is set
correctly. Hold the FX button to return to the
default setting of one zone/all notes active.
o Manual Mode Transpose (Hold FX button to
Select) - Use the Voice 1 and 2 buttons to
transpose your MIDI input notes in Manual mode
up or down by up to 4 octaves.The preset LED
will show octave shift from 0 to 4 octaves and then
up or down via a horizontal bar.
To Reset Only the MIDI Options
This allows you to reset the MIDI options to default
values without resetting any presets you’ve created.
Enter MIDI Setup mode by holding the A/B and On
footswitches.
To reset the MIDI options, hold the Manual, FX and
Voice 2 buttons for 3 seconds. Exit to normal operation
mode by pressing the On footswitch.
Performing a Factory Reset
A reset will delete all of your edited presets and return
all MIDI settings to the factory defaults.
For Advanced Users