TC-Helicon VoiceTone Harmony-M Manual - Manual (Page 22)

22
To reset all, insert the power connector while holding
the Manual and Voice 2 buttons for 3 seconds.
Harmony-M will boot normally after the memory is
initialized.
How To Change the Tuning Reference
By default, Harmony-M is tuned to A=440 Hz and the
harmony voices will sound in tune when you sing with a
keyboard tuned to A=440. If you will be playing and
singing with another instrument tuned to a different
reference e.g. a piano that has dropped in overall pitch,
you can change Harmony-M’s reference with the
following procedure.
Press and hold the Manual, Double and FX buttons
simultaneously as you plug in the power adapter. Then
place your microphone near the instrument you want to
tune to and play any single note from it. Press any button
to exit to normal function.
Note that you must also tune your keyboard to the
external reference. Your keyboard, the reference
instrument and the harmony voices’ pitch should now
match.
Note that the tuning reference is reset to A440 the next
time power is removed from Harmony-M.
How to Use MIDI CC’s
MIDI CC’s offer precise remote control of Harmony-M’s
features. These control messages are typically
transmitted from a sequencer or controller keyboard
that is equipped with assignable faders and buttons.
When using CC’s it’s necessary to:
o Assign the correct CC numbers to the faders and
buttons on your transmitting device
o Set the correct MIDI channel
o Ensure CC control is active in MIDI Setup Mode
See the table on the next pages for CC numbers and
assignments.
For Advanced Users