SUUNTO OCTOPUS II - Manual (Page 51)

51
NOTE: In case of the minutes and date, the change is made separately for both digits,
as shown by the blinking digit. In case of the hours and month, the complete number is
changed simultaneously.
4. Repeat steps 2 and 3 to change any additional values.
5. Exit the Time Setting mode with the RETURN command, i.e. by connecting all three
contacts at the same time. First make contact between the PLAN/ON and TIME/MODE
contacts and after that with the COM contact.
NOTE: The clock is on (time is elapsing) when setting it and exiting the Time Setting
mode. It is not possible to reset the seconds.
Remember to regularly check that the clock is on time especially when traveling to
different time zones, as the entry time of all dives is stored in the logbook memory.
Fig. 4.14 TIME SETTING
Scrolling through hours, minutes, month
and date, TIME/MODE & COM.
Fig. 4.15 TIME SETTING
Adjusting the ten minute reading (blinking),
PLAN/ON & COM.
COM
TIME
MODE
PLAN
ON
LOG HIS ALT SET PLAN
A
S
C
R
A
T
E
m
COM
TIME
MODE
PLAN
ON
LOG HIS ALT SET PLAN
A
S
C
R
A
T
E
m