SUUNTO COBRA User Guide User Manual
Page 98
•
MAINTENANCE
The instrument should be soaked, thoroughly rinsed with fresh water, then dried
with a soft towel after each dive. Make sure that all salt crystals and sand particles
have been flushed out. Check the display for possible moisture or water. DO NOT
use the dive computer if you detect any moisture or water inside. Contact an au-
thorized Suunto dealer for battery replacement or other service.
CAUTION!
•
Do not use compressed air to blow water off the unit.
•
Do not use solvents or other cleaning fluids that might cause damage.
•
Do not test or use the dive computer in pressurized air.
•
WATER RESISTANCE INSPECTION
The water resistance of the unit must be checked after replacing the battery or
after other service operations. The check requires special equipment and training.
You must frequently check the display for any sign of leaks. If you find moisture
inside your dive computer, there is a leak. A leak must be corrected without delay
as moisture will seriously damage the unit, even beyond repair. SUUNTO does
not take any responsibility for damage caused by moisture in the dive computer
unless the instructions of this manual are carefully followed. In the event of a leak,
immediately take the dive computer to an authorized SUUNTO dealer or distributor.
FAQs
For more information on service, please refer to FAQs on .
98