SUUNTO COBRA User Guide - Manual (Page 54)

NOTE
The dive computer will remain in the SURFACE mode at depths
less than 1.2 m/4 ft. At depths greater than 1.2 m/4 ft the instru-
ment will go into the DIVE mode automatically. However, it is re-
commended that you activate the SURFACE mode manually
before entering the water in order to perform the necessary dive
pre-checks.
6.1.1. Basic dive data
During a No-decompression dive, the following information is displayed:
•
your present depth in meters/feet
• the Altitude Adjustment setting on the left side of the center window with a wave
and mountain symbols (A0, A1, or A2) (see Table 5.4, Altitude Adjustment settings.)
• the Personal Adjustment setting on the left side of the center window with a diver
symbol and + signs (P0, P1, or P2) (see Table 5.5, Personal Adjustment settings.)
• the maximum depth during this dive in meters/ft, indicated as MAX
• the cylinder pressure in bar/psi displayed in the lower left corner
• the elapsed dive time in minutes, shown as DIVE TIME in the lower right corner
• the available no-decompression time in minutes in the center window as NO DEC
TIME and as a bar graph on the left side of the display.
• the Remaining air time
54