Sure Heat Sonoma CGR30 Natural Gas Conversion Kit - Manual (Page 9)

Sonoma CGR30
Natural Gas Conversion Instructions
6. Remove LP valve assembly from the side burner.
7. Install new NG valve assembly and bezel into the
side burner assembly. (See Fig. 34-35)
Note: The valve assembly is held in place by the
front bezel screw.
8. Connect the new gas supply hose to the side
burner valve. (See Fig. 29 again)
Note: The hose should be routed through the
same hole from which the LP regulator hose was
removed.
9. Reattach aluminum line from the new LP valve to
the side burner. (See Fig. 36)
Note: First attach the fitting attached to the
valve. then the aluminum line fitting
10. Tighten the aluminum line going from the side
burner valve to the side burner, using and
adjustable wrench. (See Fig. 36)
11. Reattach the control knob onto the valve stem,
making sure “OFF” is facing upwards. (See Fig.
32, again)
Fig 34
Fig 35
LP valve
Assembly
Fig 36
Valve Assembly
Underside of
right side
burner shelf
Attach
Second
Attach First
LP valve
Assembly