Sure Heat Sonoma CGR30 Natural Gas Conversion Kit - Manual (Page 3)

Sonoma CGR30
Natural Gas Conversion Instructions
6. Loosen the six (6) screws at the top of the heat
shield, holding the front heat shield in place.
(See Fig. 6)
7. Loosen the bottom heat shield screws located
under the bottom lip of the heat shield. (there is
one screw on each side) (See Fig. 7)
8. Push the front heat shield towards the rear of the
grill. (See Fig. 8)
9. Grasp and push the burner(s) towards the rear of
the grill to detach the burner from the valves.
(See Fig. 9)
Note: You may have one or two burner assem-
blies, depending on your grill size.
10. Angle the burners up and pull out making sure
the tabs slide up through the cutout on the sup-
port channel at the rear of the grill. (See Fig. 10)
Fig 10
Fig 6
Fig 7
Fig 8
Fig 9
Bottom Screw
(Repeat on left side)
Heat Shield
Valves
Cutouts
Tabs
Screws
under lip