Source Audio Soundblox Pro Poly-Mod Filter - Manual (Page 27)

Specifications and Troubleshooting | 27
Dimensions
• L: 7 inches (18.1cm)
• W: 6 inches (18.1cm)
• H: 2 inches (including knobs)
Total including knobs:
• H: 2.125 inches (5.5cm)
Weight
• 1.75 lbs
Power
• 110mA @ 9 VDC (max 145mA w/ Hot Hand
Wireless Adapter)
• NEGATIVE tip power jack
Audio Performance
• 115dB DNR audio ADC
• 24-bit audio conversion
• 56-bit digital data path
• Analog bypass
TROUBLESHOOTING
Noise
Near noise source
Move pedal away from power supplies and other equipment.
Other equipment Remove other effects from signal chain, see if noise persists.
Bad cables Swap out audio cables.
Hot Hand doesn’t work
Not calibrated properly
Calibrate the Hot Hand - see page 20 .
Not connected Check Hot Hand connections.
Knobs don’t work /light up
Wrong power supply
Use correct power supply as defined on pages 4 and 8 .
For additional assistance, please visit www.sourceaudio.net.
SPECIFICATIONS
If possible, dispose of the device at a recycling center. Do not dispose of the device
with the household waste.
For full compliance with EN 61000-4-6 standard, input cable must be less than
3 meters in length.