Sonics VCX750 (Serial No."X or lower)" - Manual (Page 13)

13
1. Set ON/OFF power switch to ON. The switch will illuminate and the screen will
display the power rating of the Ultrasonic Processor, cautionary notices, and the
following control parameters.
CAUTION
• Never allow liquid to spill into the converter. Do not use the cup horn without a
splash shield
• Do not allow a microtip or extender to vibrate in air for more than 10 seconds.
When working with a microtip
never allow the AMPLITUDE control to be set
above the microtip limit 40%. Ignoring these instructions will cause the microtip
to fracture.
• Do not allow the vibrating microtip to contact anything but the sample.
• When working with low surface tension liquids, do not use a probe with a
replaceable tip.
• Never energize a threaded probe without the replaceable tip, extender, or microtip
attached.
NOTE
Refer to Section IV, for general operating suggestions and ultrasonic processing
techniques.
TIME __:__:__ TEMP __ __ °C
PULSE__:__:__ AMPL __ __%
Go To Top Of Document