SmarTek Systems SAS-1 Setup Using SAS Monitor - Manual (Page 3)

SmarTek Systems (www.smarteksys.com) 3
Connecting to SAS-1 via the SAS-CT and Establishing Communication
Connect the SAS-CT (RJ-45) to the PC comm port (DB-9) using the supplied serial cable. Check
that power to the SAS-CT is present and the fuse is in place on the SAS-CT. Run the SAS
Monitor and Setup program on the PC by clicking Start/Programs/SmarTek
Systems/SAS_Monitor_V6. On the Introduction screen, click Direct. All SAS Monitor and
Setup parameters are stored in a parameter file (user_specified_name.smp) with a user
specified name and a “.smp” extension . Select the SAS Monitor parameter file (.smp) using the
standard “Open File” dialog window which is displayed after selecting the Direct button. The
SAS Monitor and Setup’s main display is shown in Figure 1.
To change parameter values in the SAS Monitor and Setup Display, left click in the upper
(increment) or lower (decrement) part of the parameter value display field. For most of the
parameters, holding the Shift key down while clicking in the parameter field increases the
increment/decrement amount.
Figure 1 SAS Monitor and Setup Main Display
Monitor
Mode
Start/Stop
Button
Status
Line
Monitor
Mode
Start/Stop
Button
Status
Line