SmarTek Systems SAS-1 Setup Using SAS Monitor User Manual
Page 21
SmarTek Systems (www.smarteksys.com)
21
Menu Options Lists
The following is a complete list of menu options in the SAS Monitor and Setup software.
File Menu
Log Flow Measurements - Enables/Disables creation of a spreadsheet ready text
measurement file in the \Arch_Data\ sub-folder (SASxxxx.log). When enabled new data
is appended to older data in the file.
Enable Manual Measurements - Enables the collection and logging of manual vehicle
counts. This capability uses a special parallel port interface (with buttons) for counting
vehicles.
Enable Power Log - Enables/Disables disk logging of the acoustic power. The file is
binary and is used by SmarTek Systems for analysis, development, demonstration, and
debugging.
Save SAS Monitor Parameter File As.. - Open a “Save File As” dialog window for
saving current SAS Monitor and Setup parameters in a new file specified by the user.
Exit - Terminates SAS Monitor and Setup.
Settings Menu
Comm Port/Set Up Comm Port - Opens a dialog window to set the PC Comm Port
parameters.
Comm Port/Find SAS Baud Rate – Starts SAS Monitor and Setup process to try to
determine SAS-1 baud rate. The progress/results of this operation are shown in the
Status Line in the lower left part of the main display.
Modem - Opens a dialog window to set the modem parameters.
Create Sensor Polling List - Opens a dialog for creating a multi-sensor polling list. This
list is used with special SAS Monitor and Setup modes for analysis, demonstration, and
testing.
Visible Message Window - Enables/Disables a text window for observation of the SAS-
1 messages.
Manual Vehicle Speed Measurement – Enables manual vehicle speed measurements
using a push button interface and measured landmarks (time from point A to B is
converted to speed).
White Plot Background - Toggles between a white background or black background
measurement display.
Flow Mode Beep - Enables/Disables a audible beep upon traffic flow message arrival.
Scroll Traffic Acoustic Image – Enables/Disables TAI scrolling from bottom up for
continuous display instead of the painting down from the top and refreshing when
displayed data reaches the bottom. The scroll TAI mode requires a Pentium running at
300 MHz or better to work well.
Lane Finder - Enables/Disables the Automatic Lane Finder Function Display.
Speed Calibration Window – Opens the Speed Calibration Window for use while
running SAS Monitor and Setup in Mode 1 (TAI display mode)