Culligan Gold Series - Manual (Page 5)

Read this Manual First
Before you operate the Gold Series Water Softening System, read this manual to become familiar
with the device and its capabilities.
Watch for Special Paragraphs
Please read the special paragraphs in this manual. Examples are shown below.
Safe Practices
Throughout this manual there are paragraphs set off by special headings.
Note: Note is used to emphasize installation, operation or maintenance information which is
important, but does not present any hazard. Example:
Caution! Caution is used when failure to follow directions could result in damage to equipment or
property. Example:
Warning! Warning is used to indicate a hazard which could cause injury or death if ignored.
Example:
Serial Numbers
The control valve serial number is located on the back of the timer case.
The media tank serial number is located on the top surface of the tank.
This publication is based on information available when approved for printing. Continuing design refinement
could cause changes that may not be included in this publication.
Products manufactured and marked by Culligan International Company (Culligan) and its affiliates are protected
by patents issued or pending in the United States and other countries. Culligan reserves the right to change the
specifications referred to in this literature at any time, without prior notice.
Culligan, Aqua-Sensor, Tripl-Hull, Flo-Pak and Soft-Minder are trademarks of Culligan International Company or
its affiliates.
Introduction
5
Note: Check and comply with your state and local codes. You must follow these guidelines.
For installations in Massachusetts, Massachusetts Plumbing Code 248 CMR shall
be adhered to. Consult your licensed plumber for installation of this system.
This system and its installation must comply with state and local regulations.
The use of saddle valves is not permitted.
Note: The nipple must extend no more than 1 inch above the cover plate.
Caution! Disassembly while under water pressure can result in flooding.
WARNING! Electrical shock hazard! Unplug the unit before removing the
cover or accessing any internal control parts.
Note: DO NOT remove or destroy the serial number. It must be referenced on request for
warranty repair or replacement.