Reznor Q6SD Option - Installation - Power Exhaust - Lt Commercial - Manual (Page 3)

INSTALLATION
INSTRUCTION
INSTALLATION INSTRUCTIONS FOR
547842 / 555578 / 555579 / 547843 / 555580 / 555581 / 555651
POWER EXHAUST USED WITH R4GM 072
P6SD, Q6SD, R6GD 024-060 UNITS
FIG URE 1
10
20
FIGURE 2
III - IN STAL LA TION
1. Disconnect all power to unit.
2. Cut and discard wire tie securing wire bundle for high voltage connection.
Important - DO NOT cut other wires. Inspect for damaged connections or loose wires.
3. Remove barometric relief hood from return duct of the economizer or if installing along with economizer omit this step.
See Figure 4.
4. Mount end switch kit and harness to economizer damper motor as shown on the next two pages.
ECONOMIZER INSTALLED
EXHAUST MOTOR & FAN
FRESH AIR HOOD
I - SHIP PING AND PACK ING LIST
Package 1 of 1 contains:
1 - Power Exhaust Assembly
1 - Fresh Air Hood
6 - #10 x ½ x 16 Hex Tec
1 - End Switch Kit
Check contents for shipping damage. Contact the
last carrier immediately if any shipping damage is
found.
II - AP PLI CA TION
The power exhaust is designed to relief excess
pressure that may occur with economizers or
building conditions.
HOR I ZON TAL APPLICATION
BAROMETRIC RELIEF
HOOD
CONTROL ACCESS
BAROMETRIC RELIEF HOOD