beautypg.com

Reznor R6GD Unit Installation Manual User Manual

Page 12

background image

12

Condensate Drain

Figure 6. Condensate Drain Location

Figure 5. Roof Top Installation

Figure 4. Ground Level Installation

Unit Size

Internal Filter Size

R6GD-X36

(2) 16” x 25” x 1”

or

(2) 16” x 25” x 2”

R6GD-X48 / X60

(2) 18” x 25” x 1”

or

(2) 18” x 25” x 2”

Table 2. Internal Filter Sizes

Removal of Internal Filter Rack (3 Phase Only)
1. Remove the return air panel from the unit.
2. Remove the height adjustment screw from the inside

of the rack.

3. Remove (1) screw securing the assembly to the coil

located on the left leg of the rack. NOTE: The assembly
can now be easily collapsed and removed from the unit.
See Figure 7 for fi lter rack securing screw locations.

Securing

Screws

Figure 7. Internal Filter Rack Location

Installing Filters in the Filter Rack (3 Phase Only)
1. Remove access panel screws from return air panel.

(Hint: Loosen the unit’s top panel screws near the
top edge of the access panel. The access panel was
designed to be captured underneath the top panel.)

2. Slide the fi rst fi lter between both guide channels of

fi lter rack and allow the fi lter to drop easily into place.

3. Verify the bottom of the fi lter is within the channels of

the rack.

4. Slide the 2nd fi lter between both guide channels of

fi lter rack.

5. Verify the bottom of the fi lter is within the channels of

the rack.

6. Replace access cover by sliding the top edge of panel

under the lip of the unit’s top panel. Secure access
panel by replacing the screws.

Removing Filters from Filter Rack (3 Phase Only)
1. Remove access panel screws from return air panel.

(Hint: Loosen the unit’s top panel screws near the
top edge of the access panel. The access panel was
designed to be captured underneath the top panel.)

2. Remove upper fi lter by gently pulling fi lter through the

access panel opening.

3. Remove lower fi lter by lifting media to top of fi lter rack.

Remove in the same manner as described in step 2.

4. Install new fi lter in the fi lter rack as described in the

previous section.