beautypg.com

Getting started – Ram Trucks 2013 3500 - User Guide User Manual

Page 21

background image

4. Attach the hook to the outboard tether strap loop (see diagram). Tighten the tether

strap according to the child seat manufacturer’s instructions.

Installing Three Child Restraints:
1. Place a child restraint on each out-

board rear seat. Route the tether
straps following the directions for
right and left seating positions, above.

2. Attach both hooks to the center tether

strap loop, but do not tighten the
straps yet.

3. Place a child restraint on the center

rear seat. Route the tether strap fol-
lowing the directions for the center
seating position, above.

4. Attach the hook to the outboard tether

strap loop.

5. Tighten the tether straps according to the child seat manufacturer’s instructions,

tightening the right and left tether straps before the center tether strap.

Installing The Child Restraint Using The Vehicle Seat Belts

• To install a child restraint, first, pull enough of the seat belt webbing from the

retractor to route it through the belt path of the child restraint and slide the latch
plate into the buckle.

• Next, extract all the seat belt webbing out of the retractor and then allow the belt

to retract into the retractor. Finally, pull on any excess webbing to tighten the lap
portion around the child restraint. Any seat belt system will loosen with time, so
check the belt occasionally, and pull it tight if necessary.

Tether Strap Through Center Tether Strap

Loop And Attached To Outboard Tether Strap

Loop

Left Outboard And Center Seating Position

Shown

GETTING STARTED

19

This manual is related to the following products: