CMS Products 674 - Manual (Page 50)

Monetary Setup HotCup Operators’ Guide
6740001 44 November, 2007
d. Press to display the desired choice.
The value of " X.XX " has two purposes:
i. First, " X.XX " tells the machine how big a bill or coin to accept even though there is not
enough change in the coin mech to cover all possible paybacks.
• For example, enter 1.00 . The machine will take a dollar bill or coin even though there
is less than $1.00's worth of change. Entering 5.00 tells the machine to take a five
even though there is less than $5.00's worth of change, and so forth.
NOTE:
This could cause a customer to be shortchanged.
• Entering 0.00 means that bills or coins will only be accepted if there is enough change
to cover them.
ii. The value of " X.XX " tells the machine how much the customer is allowed to overbuy a
product. The customer will be shortchanged when an overbuy occurs.
• For example, for a value of $0.25: if there is no change in the machine and the
customer inserts a $1.00 bill. The customer can purchase a product for $0.75 even
though the change cannot be paid back. The customer will be shortchanged.
Normally a purchase will not be approved unless all change can be paid.
• Entering 0.00 means that the vend will only be approved when the correct change can
be returned (overbuy disabled).
e. CONTINUE.
SELECT CARD READER AND OPTIONS
a. Press , then press until the current card reader is shown in the display.
b. Press to choose the desired card reader. Your choices are: NO CARD , DUMB
CARD , or MDB CARD .
c. Press until one of the following is displayed:
REVALUE.ON Allows credit to be transferred onto the card
REVALUE.OFF Credit cannot be transferred to the card
d. Press to display the desired choice.
e. CONTINUE.