CMS Products 674 - Manual (Page 26)

Initial Setup HotCup Operators’ Guide
6740001 20 November, 2007
HYDROLIFE BRAND
INSTALLATION:
a. Place the filter inside the canister. Be sure the o-ring is seated in the canister just below the
threads.
b. Screw the canister and filter assembly onto the filter head until it comes to a stop.
c. Open the water valve on the inlet line by rotating the handle to the vertical position as shown.
REMOVAL:
a. Close the valve on the inlet line by rotating the handle into the horizontal position as shown.
b. Relieve water pressure by performing two or three water throws (See “Programming The
HotCup” on page 34).
c. Unscrew the filter and canister assembly from the filter head. Remove the filter from the
canister.
FILTER
CANISTER
O-RING
OPEN
POSITION
HYDROLIFE
FILTER HEAD
INSTALL
REMOVE
OPEN
POSITION
CLOSED
POSITION
VALVE