CMS Products 674 - Manual (Page 30)

Initial Setup HotCup Operators’ Guide
6740001 24 November, 2007
MDB Coin Mechanism
Install the coin mechanism as follows:
WARNING
Make sure the main power switch is turned OFF before
you work on the merchandiser. Failure to do so
could result in death or injury.
a. Turn OFF the main power switch. Refer to the instructions provided with the coin mechanism
and remove the coin validator assembly.
b. Loosen the coin mechanism mounting screws on the merchandiser so they stand off about 1/
8" (0.3 cm).
c. Position the coin mechanism so the three keyed holes fit over the mounting screws. Pull
down on the coin mechanism to seat the screws in the keyways.
d. Tighten the mounting screws and reinstall the coin validator assembly.