PRG Mbox Designer User Manual v3.7 - Manual (Page 53)

MBOX ® MEDIA SERVER USER MANUAL 45
APPLICATION WINDOW
Overview
The Mbox Designer application window allows the server’s output to be viewed in either Window or Fullscreen mode
on the preview monitor.
Fullscreen - While in Fullscreen mode, the server’s output (i.e., video) will be displayed at "full screen" without any
user interface showing. In this mode, the output will also be visible on the Stage output of the Dual I/O module.
Window - While in Window mode, the application’s user interface will be displayed. In this mode, the output will NOT
be visible on the Stage output of the Dual I/O module. The Window mode interface contains three tabs: Mbox, Setup,
and Pixel Map as shown in this sample screen below:
The function of the three Window mode tabs is as follows:
+ Mbox tab - used for previewing the server’s video output.
+ Setup tab - used to configure the server. Refer to "Setup" on page 46 for more details.
+ Pixel Map tab - used to configure the Pixel Map and its Art-Net output. Refer to "Pixel-Mapping" on page 107 for
more details.
CAUTION! While in Window mode, there is no visible output from the Dual I/O stage outputs. (A video signal still
exists, but the output is blacked out.)
Fullscreen Mode Window Mode
Output to: Preview (Monitor) and Stage Output to: Preview (Monitor) only