PRG Mbox Director User Manual v3.6.1 - Manual (Page 17)

MBOX ® DIRECTOR USER MANUAL 11
Step 7. At MBOX main window, click on Setup tab.
Step 8. At Network section, set Sync to Ethernet 1 and CITP to Ethernet 1 as shown below:
Step 9. When MBOX is launched, it will atomically launch the MBOX Daemon application. Confirm that MBOX
Daemon is running by pressing [  D] (while MBOX server is in Window mode).
Step 10. At MBOX Daemon window, verify that Network Interface reads: Ethernet 1. (It should update automatically.)
Step 11. At MBOX server, connect Ethernet cable to Ethernet 1 port (refer back to Figure 2).
Step 12. At Mac computer, connect other end of Ethernet cable to Ethernet 1 port.
Step 13. At this point, MBOX Director will be synchronized with the network. Proceed to "Adding Fixtures" on
page 12.