PRG Mbox Director User Manual v3.8a - Manual (Page 17)

MBOX ® DIRECTOR USER MANUAL 11
Step 7. At Mbox main window, click on Setup tab.
Step 8. At Network Ports section, set Sync to Ethernet 1 and CITP to Ethernet 1 as shown below:
Step 9. When Mbox is launched, it will atomically launch the Mbox Daemon application. Confirm that Mbox
Daemon is running by pressing [  D] (while Mbox server is in Window mode).
Step 10. At Mbox Daemon window, verify that Network Interface reads: Ethernet 1. (It should update automatically.)
Step 11. At Mbox server, connect Ethernet cable to Ethernet 1 port (refer back to Figure 2).
Step 12. At Mac computer, connect other end of Ethernet cable to Ethernet 1 port.
Step 13. At this point, Mbox Director will be synchronized with the network. Proceed to "Adding Fixtures" on
page 12.