Philips FW754P37 - Manual (Page 27)

RECORDING
Dubbing tapes (from tape deck2 to tape deck 1)
1 Load the prerecorded tape into tape deck 2 and a
blank tape into tape deck 1.
— Make sure that both tapes have their full spool to
the left.
2 Press DUBBING to switch between normal and high
speed dubbing.
-* "ifuRfint." (normal speed) or TRSi" (high speed)
will be displayed.
The HSD flag appears on the display for high speed
dubbing.
3 Press PAUSE on tape deck 1.
4 Press RECORD on tape deck 1.
5 Press PLAY ► on tape deck 2.
— Recording will start automatically.
-* The REC flag starts flashing.
6 Press STOP »OPEN on tape deck 1 and 2 to stop
dubbing.
Notes:
- At the end of side A, flip the tapes to side B and
repeat the procedure.
- Dubbing of tapes is only possible from tape deck 2 to
tape deck I.
- To ensure good dubbing, use tapes of the same length.
- During high speed dubbing in Tape mode, the sound is
reduced to a low volume.
AUX
Selecting External Equipment______________
If you have connected the audio out terminals of the
external equipment (TV, VCR, Laser Disc or DVD player) to
the AUX IN terminals, you can hear the sound from the
system.
• Press AUX to select the external mode.
-* "R ua " will be displayed.
Note:
- All the sound control features (e.g. DSC, DBB, etc.) are
available for selection.
MAINTENANCE
Maintenance
Cleaning the Cabinet
• Use a soft cloth slightly moistened with a mild
detergent solution. Do not use a solution containing
alcohol, spirits, ammonia or abrasives.
Cleaning Discs
• When a disc becomes dirty, clean it with a cleaning
cloth. Wipe the disc from the center out.
• Do not use solvents such as benzine, thinner,
commercially available cleaners, or antistatic spray
intended for analog records.
Cleaning the CD lens
• After prolonged usage, dirt of dust may accumulate at
the CD lens. To ensure good playback quality, clean
the CD lens with Philips CD Lens Cleaner or any
commercially available. Follow the instructions
supplied with the Lens Cleaner.
Cleaning the Heads and the Tape Paths
• To ensure good recording and playback quality, clean
the heads, capstan(s) and pressure roller(s) after every
50 hours of tape operation.
• Use a cotton swab slightly moistened with cleaning
fluid or alcohol.
• You can also clean the heads by playing a cleaning
tape through once.
Demagnetizing the heads
• Use a demagnetizing tape available at your dealer.
27