Compex Systems WPE53G - Manual (Page 164)

Page 158
S S t t e e p p 5 5 : :
From the Start menu, click Run and type cmd. When the command prompt window
appears, type in the following command:
X:\recovery\TFTP -i 192.168.168.1 PUT image_name.IMG , where X refers to your CD
drive and image_name.IMG refers to the firmware filename found in the Recovery
folder of the Product CD.
S S t t e e p p 6 6 : :
If you have downloaded a newer firmware and have saved it in your local hard disk
as: C:\accesspoint\accesspointxxx.IMG, then replace the command with this new
path and firmware name. For example:
C:\accesspoint\TFTP –i 192.168.168.1 PUT accesspointxxx.img
The recovery process takes place.
You can monitor the progress of the recovery process with the diagnostic LED.
When firmware restoration is complete, reboot the access point and it will be ready
to operate.